Tag: Drain-tile Depressurization

Plymouth – 4/22/2016

Location: Plymouth, MN Cost: $1450 Initial Radon Level: > 4.0 pCi/L Post Mitigation Radon Level: 0.4 pCi/L This radon mitigation system was very effective since there was drain tile already under the floor.  We added a sealed sump basket lid, with a clear access hole so that you can access the sump pump if needed.  We also used rubber couplers on the radon vent… Read more → about Plymouth – 4/22/2016

Plymouth – 07/02/2015

Location: Minneapolis, MN Cost: $2675 Initial Radon Level: 10.0 pCi/L Post Mitigation Radon Level: 0.7 pCi/L This was an average install for us.  We sealed the sump basket, installed a view port and radon vent pipe.  Using the drain tile system under the floor allows for the radon mitigation system to collect the maximum amount of radon.  The pipe went across the basement mechanical… Read more → about Plymouth – 07/02/2015

Eden Prairie – 06/11/2015

Location: Eden Prairie, MN Cost: $1475 Initial Radon Level: >4.0 pCi/L Post Mitigation Radon Level: 0.5 pCi/L We have found that newer homes are much easier to install radon mitigation systems.  The usually have: an unfinished portion of the basement an attached garage they have drain tile systems already installed the garage already has electrical outlets. These four things allow for the maximum radon reduction… Read more → about Eden Prairie – 06/11/2015

Golden Valley – 06/11/2015

Location: Brooklyn Park, MN Cost: $1675 Initial Radon Level: 6.8 pCi/L Post Mitigation Radon Level: 0.2 pCi/L This home in Golden Valley has a slightly complicated radon mitigation system, since there had been many remodels to the home.  The basement had two different floors and there was no easy way to route the pipe though the home.  The lowest basement floor had a retrofitted… Read more → about Golden Valley – 06/11/2015